![]() ![]() Trace door onto brown card, add a small tab to the left side, fold tab and adhere to the house via tab. Trace the haunted house template onto black, orange, yellow and brown card and black dotty patterned paper and assemble as shown. ![]() Add 140 x 35mm strips of yellow, orange, red and black card to the inside of the orange panel.Push the cut area inwards to create a tab which is the base for your pop-up. Score a line between the two parallel lines on both sides of the card. Using a ruler to draw two parallel vertical lines, using the points as a guide, cut with a craft knife. Mark 30mm above and below each of these two points. Measure and mark at 25mm on either side of this point. ![]() Measure and mark the centre of the fold at 70mm. Score and fold a 140 x 280mm piece of orange card in half.Add a red gem in each corner of the card. Use sticky foam pads to add a sentiment from the Halloween printables onto the left-hand side of the ribbon.Wrap ribbon around the bottom of the panel, add sticky foam pads and three monsters to the back of the panel then affix it onto the card front. Trim stone-wall paper from the Halloween printables to 12.5 x 12.5cm then die cut a 10cm-wide circle through the centre.Add sticky foam pads and a fussy-cut monster from the Halloween printables to the back of the panel then stick it on top of the orange panel on the card front. Trim purple card to 13 x 13cm then die cut an 8cm-wide circle through the middle.Trim orange card to 13.5 x 13.5cm then die cut a 6cm-wide circle through it and attach a small monster and a spooky background scene from the Halloween printables behind the aperture. For this haunted house papercraft card, create a 14 x 14cm, top-fold card base then cover the front with some black card. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |